Replacement Swivel Blade Clamps for Mk. III Saws bench pin re-setting sweat soldered panels that

re-setting sweat soldered panels that had warped during the first soldering

1 oz (172 gm)

which will cut in all directions

These blades have very wide gullets

Replacement Swivel Blade Clamps for Mk. III Saws bench pin re-setting sweat soldered panels thatThis replacement set of swivel blade clamps is for newer (post 2010) Mk. III saws only. They will NOT fit older (pre 2010) Mk. III saws, Mk. IV heavy duty saws, or Coping saws. If you have a birdcage titanium saw, these are the swivels you need. Replacement Instructions Use a 5 64" allen wrench to loosen the set screws in the clamp at the handle end of the saw and remove clamp. Replace with the new clamp, re tighten the set screws. Note the location